Search results

Filters

  • Journals
  • Authors
  • Keywords
  • Date
  • Type

Search results

Number of results: 17
items per page: 25 50 75
Sort by:

Abstract

On the basis of 35 one-hour series of the measurement of the wind velocity, read out every two minutes, the wind structure at the Arctowski Station, situated on Admiralty Bay, King George Island, was analysed. Very strong turbulence was found with air flow directions from over the area of the Island (S, SW. W and NW) and laminarity with directions from SE, E, NE and partly N, i.e. when the air flows from Admiralty Bay or from over the open waters of Bransfield Strait. The qustiness coefficient, the relationship between the maximum and mean velocities and the intensity of turbulence were determined for the two flow types. Two extremely different cases, in terms of flow character, were considered, by determining for them the distributions of instantaneous velocities and those of oscillations.
Go to article

Abstract

Power spectrum techniques were applied to two time series of wind speed values recorded at the Arctowski Station in order to investigate the influence of turbulent and laminar air flow on the quasi-periodicity of the micro-scale wind structure.
Go to article

Abstract

The analysis of speed and direction distribution of upper wind in the layer up to 3500 m was carried out on the basis of pibal ascents performed over the Admiralty Bay (King George Island, South Shetland Islands).
Go to article

Abstract

This article considers designing of a renewable electrical power generation system for self-contained homes away from conventional grids. A model based on a technique for the analysis and evaluation of two solar and wind energy sources, electrochemical storage and charging of a housing area is introduced into a simulation and calculation program that aims to decide, based on the optimized results, on electrical energy production system coupled or separated from the two sources mentioned above that must be able to ensure a continuous energy balance at any time of the day. Such system is the most cost-effective among the systems found. The wind system adopted in the study is of the low starting speed that meets the criteria of low winds in the selected region under study unlike the adequate solar resource, which will lead to an examination of its feasibility and profitability to compensate for the inactivity of photovoltaic panels in periods of no sunlight. That is a system with fewer photovoltaic panels and storage batteries whereby these should return a full day of autonomy. Two configurations are selected and discussed. The first is composed of photovoltaic panels and storage batteries and the other includes the addition of a wind system in combination with the photovoltaic system with storage but at a higher investment cost than the first. Consequently, this result proves that is preferable to opt for a purely photovoltaic system supported by the storage in this type of site and invalidates the interest of adding micro wind turbines adapted to sites with low wind resources.
Go to article

Abstract

By means of small wind turbines, it is possible to create distributed sources of electricity useful in areas with good wind conditions. Sometimes, however, it is possible to use small wind turbines also in areas characterized by lower average wind speeds during the year. At the small wind turbine design stage, various types of technical solutions to increase the speed of the wind stream, as well as to optimally orientate it, can be applied. The methods for increasing the efficiency of wind energy conversion into electricity in the case of a wind turbine include: the use of a diffuser shielding the turbine rotor and the optimization of blades mounted on the turbine rotor. In the paper, the influence of the diffuser and rotor blades geometry on the efficiency of an exemplary wind turbine for exploitation in the West Pomeranian Province is investigated. The analyses are performed for three types of the diffuser and for three types of rotor blades. Based on them, the most optimal shapes of the diffuser and blades are selected due to the efficiency of the wind turbine. For the turbine with the designed diffuser, calculations of the output power for the assumed different values of the average annual wind speed and the constant Betz power factor and the specified generator efficiency are made. In all the analyzed cases, the amount of energy that can be generated by the turbine during the year is also estimated. Important practical conclusions are formulated on the basis of these calculations. In the final part of the paper, a 3D model of the wind turbine with the diffuser and rotor blades chosen based on earlier analyses is presented. As a material for the diffuser and rotor blades, glass fiber type A is applied. By means of calculations using the finite element method, the limit displacement of the turbine structure under the influence of a hurricane wind are determined. Based on these calculations, the correctness of the modelled small wind turbine structure has been demonstrated.
Go to article

Abstract

Traps to catch microfauna transported by wind were installed on already colonised by plants area, in the vicinity of the glacier. After 6-week-exposition 859 individuals of microfauna were caught, of which Nematoda constituted 71%, Tardigrada 22% and Rotifcra 7%. Number of microfauna individuals caught depended on distance from the already colonised areas and presence of plant parts, together with which animals can be transported more easily. Microfauna connected with vegetation, which is transferred together with plant parts, was transported in higher numbers. Probably these taxa (i.e. Diphascon within tardigrades and Dorylaimidae within nematodes) colonise new habitats at first, but other species dominate later in freshwater bodies.
Go to article

Abstract

Obervations of wind directions and air temperatures in Hornsund, Spitsbergen, in 1978—1985 were used to compute frequency distribution of wind directions and mean air temperatures at particular wind directions. Prevailing easterly winds (60°, 90° and 120°) resulted in lower air temperatures (to —2.2°C) than winter and spring means and in higher (nearly 1°C) than summer and autumn mean temperatures. Greatest positive deviations from mean seasonal temperatures are observed in winter at southerly and southwesterly winds and reach 10°C. Greatest negative deviations from mean seasonal temperatures are noted at northerly winds (330° and 360°) in autumn and reach —3.7°C.
Go to article

Abstract

Increasing the share of energy production from renewable sources (RES) plays a key role in the sustainable and more competitive development of the energy sector. Among the renewable energy sources, the greatest increase can be observed in the case of solar and wind power generation. It should be noted that RES are an increasingly important elements of the power systems and that their share in energy production will continue to rise. On the other hand the development of variable generation sources (wind and solar energy) poses a serious challenge for power systems as operators of unconventional power plants are unable to provide information about the forecasted production level and the energy generated in a given period is sometimes higher than the demand for energy in all of the power systems. Therefore, with the development of RES, a considerable amount of the generated energy is wasted. The solution is energy storage, which makes it possible to improve the management of power systems. The objective of this article is to present the concept of electricity storage in the form of the chemical energy of hydrogen (Power to Gas) in order to improve the functioning of the power system in Poland. The expected growth in the installed capacity of wind power plants will result in more periods in which excess energy will be produced. In order to avoid wasting large amounts of energy, the introduction of storage systems is necessary. An analysis of the development of wind power plants demonstrates that the Power to Gas concept can be developed in Poland, as indicated by the estimated installed capacity and the potential amount of energy to be generated. In view of the above, the excess electricity will be available for storage in the form of chemical energy of hydrogen, which
Go to article

Abstract

Wind energy has achieved prominence in renewable energy production. There fore, it is necessary to develop a diagnosis system and fault-tolerant control to protect the system and to prevent unscheduled shutdowns. The presented study aims to provide an experimental analysis of a speed sensor fault by hybrid active fault-tolerant control (AFTC) for a wind energy conversion system (WECS) based on a permanent magnet synchronous generator (PMSG). The hybrid AFTC switches between a traditional controller based on proportional integral (PI) controllers under normal conditions and a robust backstepping controller system without a speed sensor to avoid any deterioration caused by the sensor fault. A sliding mode observer is used to estimate the PMSG rotor position. The proposed controller architecture can be designed for performance and robustness separately. Finally, the proposed methodwas successfully tested in an experimental set up using a dSPACE 1104 platform. In this experimental system, the wind turbine with a generator connection via a mechanical gear is emulated by a PMSM engine with controled speed through a voltage inverter. The obtained experimental results show clearly that the proposed method is able to guarantee service production continuity for the WECS in adequate transition.
Go to article

Abstract

In renewable systems, there may be conditions that can be either network error or power transmission line and environmental conditions such as when the wind speed is unbalanced and the wind turbine is connected to the grid. In this case, the control system is not damaged and will remain stable in the power transmission system. Voltage stability studies on an independent wind turbine at fault time and after fixing the error is one of the topics that can strengthen the future of independent collections. At the time of the fault, the network current increases dramatically, resulting in a higher voltage drop. Hence the talk of fast voltage recovery during error and after fixing the error and protection of rotor and grid side converters against the fault current and also protection against rising DC voltage (which sharply increases during error) is highly regarded. So, several improvements have been made to the construction of a doubly-fed induction generator (DFIG) turbine such as: a) error detection system, b) DC link protection, c) crow bar circuit, d) block of the rotor and stator side converters, e) injecting reactive power during error, f) nonlinear control design for turbine blades, g) tuning and harmonization of controllers used to keep up the power quality and to stabilize the system output voltage in the power grid. First, the dynamic models of a wind turbine, gearbox, and DFIG are presented. Then the controllers are modeled. The results of the simulation have been validated in MATLAB/Simulink.
Go to article

Abstract

In the summer 1980-1981, in the Antarctic areas, in the coastal zone of Admiralty Bay (King George Island), complex measurements were carried out in order to investigate the proportion of wind gustiness in the processes generating marine spray systems and stimulating aerosol mass exchange between the sea and the atmosphere.
Go to article

Abstract

The investigations carried out during the 5th Antarctic Expedition of the Polish Academy of Sciences allowed to collect the data concerning specificity of the dynamics of sea-salt nuclei dispersed in the Antarctica region. At the established measuring point measurements at three levels were carried out, basing on which the required profile of the wind characteristics at different heights a.s.l. were obtained.
Go to article

Abstract

The frequency of wind occurrence at sectors each 30° as well as mean air temperature at particular wind direction were accounted for the warmest and the coldest year of the investigation period 1978—1987 at Polish Antarctic „Arctowski" Station. The effect of orography on wind direction and air temperature was determined. A great rate of dependence of air temperature and wind direction upon atmospheric circulation type was found. High air temperature at the winds from 300° and 330° directions is related both to the kind of air mass and foehn phenomena.
Go to article

Abstract

Observations from 1978—81, 1983 and 1985 collected at the Polish Polar Arctowski Station (King George Island, South Shetland Islands) were used to calculate frequencies of wind directions in 30° sectors and mean air temperatures observed at each wind direction. Results reveal that all over the year the warmest air masses flow onto the South Shetland Islands from the northwest while the coolest ones from the southeast and east.
Go to article

Abstract

“Domani è un altro giorno” (Tomorrow is another day): the translation of “Via col vento” (Gone With the Wind) as an idiomatic channel – Gone With the Wind has contributed to the planet’s collective memory, not only because a great percentage of the world’s population has identified with the characters and the stories within, but also because, on a linguistic level, the novel has set in motion considerable reuse phenomena. One wonders how much and in what way the phraseology within the text has influenced contemporary Italian and how translators have approached the original text when preparing the Italian editions of the novel.
Go to article

Abstract

The article presents selected issues from the Polish Energy Policy draft until 2040. From many issues, the authors chose the ones they considered the most revolutionary. Firstly, the National Power System should be restructured to meet the challenges of a changing environment, be adapted to the growing demand for electricity, and at the same time have the least impact on the natural environment. These goals can be achieved through reforms to reduce the importance of coal in the energy mix and the development of renewable energy sources, especially offshore wind energy. The next tasks are the development of electromobility, enabling the reduction of pollution caused by transport, and, in the longer term, after 2030, the development of nuclear energy in place of the withdrawn coal power.
Go to article

Abstract

This article, as far as possible based on the available literature, empirical measurements, and data from mesoscale models describes and compares expected wind conditions within the Baltic Sea area. This article refers to aspects related to the design and assessment of wind farm wind resources, based on the author’s previous experience related to onshore wind energy. The consecutive chapters of this publication are going to describe the present state and the presumptions relating to the development of wind energy within the Baltic Sea area. Subsequently, the potential of the sea was assessed using mesoscale models and empirical data from the Fino 2 mast that is located approximately 200 kilometers away from the majority of areas indicated in the Polish marine spatial development plan draft of Poland for offshore wind farm development (Maritime Office in Gdynia 2018). In the chapter describing mesoscale models, the author focused his attention on the GEOS5.12.4 model as the source of Modern-Era Retrospective Analysis for Research and Application 2 data, also known as MERRA2 (Administration National Aeronautics and Space Agency, 28), which, starting from February 2016, replaced MERRA data (Thogersen et al. 2016) and have gained a wide scope of applications in the assessment of pre-investment and operational productivity due to a remarkable level of correlation with in-situ data. Model-specific data has been obtained for eight locations, which largely overlap with the locations of the currently existing offshore wind farms within the Baltic Sea area. A significant part of this publication is going to be devoted to the description of the previously mentioned Fino 2 mast and to the analysis of data recorded until the end of 2014 by using the said mast (Federal Maritime and Hydrographic Agency 2018). The analysis has been carried out by means using scripts made in the VBA programming language, making it easier to work with large chunks of data. Measurements from the Fino 2 mast, together with long-term mesoscale model-specific measurements can be used, to some extent, for the preliminary assessment of wind farm energy yield in the areas designated for the development of renewable energy in the Polish exclusive maritime economic zone (Maritime Office in Gdynia 2018). In the final part of this article, pieces of information on the forecasted Baltic Sea wind conditions, especially within the exclusive economic zone of Poland, are going to be summarized. A major focus is going to be put on the differences between offshore and onshore wind energy sources, as well as on further aspects, which should be examined in order to optimize the offshore wind power development.
Go to article

This page uses 'cookies'. Learn more