The paper presents the results of studies on the changes in the PAHs concentration during pre-filtration and ultrafiltration (UF) processes. In the study, biologically treated wastewater (after denitrification and nitrification processes), discharged from the biological treatment plant and used in coke plant, was used. A gas chromatography-mass spectrometry (GC-MS) was used in order to qualify and quantify the PAHs. Sixteen PAHs listed by EPA were determined. The wastewater samples were collected three fold and initially characterized for the concentration of nitrate nitrogen, ammonium nitrogen, COD, TOC and pH. In the first step, wastewater was filtrated on the sand bed. Total concentration of 16 PAHs in the treated wastewater before initial filtration was in the range of 44.8‒53.5 mg/L. During the process the decrease in the concentration of the most studied hydrocarbons was observed. Concentration of PAHs after initial filtration ranged from 21.9 to 38.3 μg/L. After the initial filtration process the wastewater flew to the ultrafiltration module and then was separated on the membrane (type ZW-10). The total concentration of 16 PAHs in the process of ultrafiltration was in the range of 8.9‒19.3 mg/L. The efficiency of removal of PAHs from coke wastewater in the process of ultrafiltration equaled 66.6%. Taking into account the initial filtration, the total degree of removal of PAHs reached 85%. The obtained results indicate the possibility of using the ultrafiltration process with the initial filtration as additional process in the coke wastewater treatment.
The work presents examination results of the common determination of PAHs and PCBs in industrial sludge and supernatants. Sewage sludge was taken from the wastewater treatment plant, and supernatants were obtained by their centrifuging. The prepared samples of sewage sludge and supernatants were subjected to extraction with applying the mixture of organic solvents. Cyclohexane and dichloromethane were used for constant samples, and methanol, cyclohexane and dichloromethane - for liquid. Extracts, after separation from samples of sewage sludge and supernatants, were cleared on the silica gel in vacuum conditions and concentrated in the stream of nitrogen. In such prepared extracts there was conducted the qualitative-quantitative analysis of 16 PAHs using the GC-MS system. Next, the samples were evaporated and poured with water and methanol until the clear solution was obtained. Extracts were cleared on octadecyl C18 columns, and then concentrated in the nitrogen stream. In these extracts PCBs was also determined with the application of the gas chromatograph with mass spectrometer. The range of concentrations 16 PAHs in sewage sludge equalled 10-16 mg/kgd.w. Summary average concentration 16 PAHs in supernatants was reached 17 μg/L. Average recovery of PAHs introduced to sewage sludge in the form of reference mixture was 78% (with consideration of naphthalene). In the case of supernatants, the average value of recovery reached 60%. Average PCBs concentration in supernatants equalled 10 ng/L. For sewage sludge the sum of marked PCBs was an average 1.23 μg/kgd.w.. In the case of particular PCBs the percentage recovery of the reference mixture for supernatants was 86%, while for sewage sludge it was 55%.