In this article the main problems related with the proper choice of the design and operation parameters of vacuum installation in vacuum moulding system have been discussed. In such system a vacuum are generated using electric-driven vacuum pumps. The aim of the experiment is to evaluate the performance of a vacuum system basing on registered plots of selected electric power parameters of the power-supplying system of the pumps with parallel measurements instantaneous values of pressure in selected points of model stand. The measurements system for power-supply unit has incorporated the recorders of instantaneous current and voltage values. Following the suitable numerical procedure, the experimental data are analysed to yield mathematical relationships between the variations of the generated vacuum pressure levels and variations of selected electric power parameters. According to the authors, the applied measurements system of the parameters of a vacuum-assisted installation may become an effective and easy practical method of evaluating the performance of such installations, used also in industry.
This paper summarizes the activity of the chosen Polish geodetic research teams in 2015–2018 in the fields of Earth: rotation, dynamics as well as magnetic field. It has been prepared for the needs of the presentation on the 27th International Union of Geodesy and Geodynamics General Assembly, Montreal, Canada. The part concerning Earth rotation is mostly focused on the use of modelling of diurnal and subdiurnal components of Earth rotation by including low frequency components of polar motion and UT1 in the analysis, study of free oscillations in Earth rotation derived from both space-geodetic observations of polar motion and the time variation of the second degree gravitational field coefficients derived from Satellite Laser Ranging (SLR) and Gravity Recovery and Climate Experiment (GRACE) observations, new methods of monitoring of Earth rotation, as well as studies on applications of the Ring Laser Gyroscope (RLG) for direct and continuous measurements of changes in Earth rotation and investigations of the hydrological excitation of polar motion. Much attention was devoted to the GRACE-derived gravity for explaining the influence of surface mass redistributions on polar motion. Monitoring of the geodynamical phenomena is divided into study on local and regional dynamics using permanent observations, investigation on tidal phenomena, as well as research on hydrological processes and sea level variation parts. Finally, the recent research conducted by Polish scientists on the Earth’s magnetic field is described.
Traffic related noise is currently considered as an environmental pollution. Paper presents results of multidirectional study attempting to serve urban traffic without the need to erect noise barriers interfering urban space. Initial concept of the road expansion included construction of 1000 m of noise barriers dividing city space. Improvement in the acoustic conditions after construction completion is possible due to the applied noise protection measures: vehicle speed limit, smooth of traffic flow, use of road pavement of reduced noise emission and the technical improvement of the tramway.
Blast furnace and cupola furnace are furnace aggregates used for pig iron and cast iron production. Both furnace aggregates work on very similar principles: they use coke as the fuel, charge goes from the top to down, the gases flow against it, etc. Their construction is very similar (cupola furnace is usually much smaller) and the structures of pig iron and cast iron are very similar too. Small differences between cast iron and pig iron are only in carbon and silicon content. The slags from blast furnace and cupola furnace are very similar in chemical composition, but blast furnace slag has a very widespread use in civil engineering, primarily in road construction, concrete and cement production, and in other industries, but the cupola furnace slag utilization is minimal. The contribution analyzes identical and different properties of both kinds of slags, and attempts to explain the differences in their uses. They are compared by the contribution of the blast furnace slag cooled in water and on air, and cupola furnace slag cooled on air and granulated in water. Their chemical composition, basicity, hydraulicity, melting temperature and surface were compared to explain the differences in their utilization.
This paper presents the summary of research activities carried out in Poland in 2011–2014 in the field of Earth rotation and geodynamics by several Polish research institutions. It contains a summary of works on Earth rotation, including evaluation and prediction of its parameters and analysis of the related excitation data as well as research on associated geodynamic phenomena such as geocentre motion, global sea level change and hydrological processes. The second part of the paper deals with monitoring of geodynamic phenomena. It contains analysis of geodynamic networks of local, and regional scale using space (GNSS and SLR) techniques, Earth tides monitoring with gravimeters and water-tube hydrostatic clinometer, and the determination of secular variation of the Earth’ magnetic field.