The possibility of acoustic wave propagation in optical waveguides creates new prospects for simultaneous transmission of laser beams and ultrasonic waves. Combined laser-ultrasonic technology could be useful in e.g. surgical treatment. The article presents the results of experimental studies of transmission of ultrasonic wave in optical fibres, the core of which is doped by 7.5% of TiO2, using a sandwich-type transducer. It also presents amplitude characteristics of an ultrasonic signal propagated in the optical fibre. Authors studied the effect which the length of the fibre has on the achieved output signal amplitudes. They presented the relation of the output signal amplitude from a capacitive sensor to the power applied to the sandwich-type transducer. The obtained results were compared with the results produced when using an optical fibre with a core doped by 3% of GeO2, in order to select optical fibre suitable for simultaneous transmission of ultrasonic waves and laser rays.
There exist some possibilities for simultaneous delivery of laser radiation and ultrasounds of low frequency and high intensity: introducing ultrasound oscillations in the optical fiber by the rigid connection of the fiber to the vibrating element and non-contact influence of the ultrasonic wave on the laser beam. The article presents the results of Matlab simulations and experimental studies of influence of the ultrasonic wave on the laser beam. A role of the air gap, and its influence on laser-ultrasonic transmission in optical fiber was examined. Advantages and disadvantages of both solutions of interaction of ultrasonic and optical waves in, e.g., surgical applications are discussed.
This article presents the results of experimental studies of simultaneous transmission of ultrasonic waves and laser signals in optical fibers by the use of both the optical single mode and multimode fiber couplers. This work was aimed, among other things, at the study of the way the acoustic energy affects a laser beam. The light wave was guided into one of the coupler's arms. The optical power applied to one input of the coupler is separated into two coupler outputs according to the rate determined by the coupling coefficient. Only an ultrasonic wave generated by a sandwich type transducer is applied to the other arm of the coupler. In this experiment, as in case of the light wave, the acoustic power is separated into both the outputs. One can observe the interaction of both the waves on the two outputs - a modulation of the light wave by means of the ultrasonic wave is possible. The output signal was detected using a PIN diode and an optical power meter (OPM). Temporary courses were observed on an oscilloscope screen. The simultaneous transmission of ultrasounds and optical radiation in optical fibers can be used in the construction of medical equipment.